Control file listing for: Generic

This is the Embosser Control File. Changing this file has no effect at all.

• # *** Embosser definition unchanged since 11/22/2006
• # This entry is describes the baseline that is internally setup baseline properties of each embosser. All embosser
• # entries build on top of these settings entry. Notice the StartLeftMargin command means that you only need to.
• # mark the embossers that start their count on zero. Changing this entry in the emb.elt file has no effect. It
• # is here to display these baseline settings
• # 11/22/2006 -- added support for 13 inch paper
• # No escape sequences used
• Baud = 9600
• DataBits = 8
• StopBits = 1
• StartLeftMargin = 1
• MaximumCells = 42
• MaximumLines = 27
• Driver = "Emb_GenericEmbosserDriver"
• BreakLimits
• HelpPage = "Generic.htm"
• Form "A4" = 83 x 117 ; SinglePage ; 35 x 29 ; 30 x 28
• Form "10_n" = 85 x 100 ; SinglePage ; 34 x 22 ; 32 x 22
• Form "11_n" = 85 x 110 ; SinglePage ; 34 x 27 ; 32 x 25
• Form "11_w" = 115 x 110 ; SinglePage ; 44 x 27 ; 40 x 25
• Form "12_n" = 85 x 120 ; SinglePage ; 34 x 30 ; 32 x 28
• Form "12_w" = 115 x 120 ; SinglePage ; 44 x 30 ; 40 x 28
• Form "13_n" = 85 x 130 ; SinglePage ; 34 x 32 ; 32 x 30
• Form "13_w" = 115 x 130 ; SinglePage ; 44 x 32 ; 40 x 30
• SortToTop