Control file listing for: Enabling Romeo Pro LE Wide
This is the Embosser Control File. Changing this file affects the embosser is supported. Support is also related to the generic embosser entry in the table
# *** Embosser definition unchanged since 09/24/2009
# To use this embosser definition. you must set this parameter
# in the embosser:
# - Label Mode (50.1e)
# It is also supposed that you are finding the top of form
# by some process external to DBT before sending a job from DBT.
#
# If you line up the forms to leave more than the tiniest of top
# margins. you will not be able to fit the maximum number of lines
# on the label that DBT will allow. In general. we advise using
# DBT's Recommended lines per page settings to leave an adequate
# top an bottom margin.
#
# Note that the form definitions below assume that all labels
# are 11 inches wide. and will support 40 cell braille. This is
# not likely to be true of your labels. To prevent line overruns.
# you should set DBT's Desired cells per line to something
# that will fit on your label. and are advised to create a
# template for labels that you will use repeatedly.