Control file listing for: Nippon Super Gemini (small spacing)

This is the Embosser Control File. Changing this file affects the embosser is supported. Support is also related to the generic embosser entry in the table

• # *** Embosser definition unchanged since 03/31/2011
• # Because of the small spacing. interpoint is not possible. Use (Nippon Telesoft Gemini) for interpoint.
• # Using Proprietary driving sequences. similar to 55
• # Proprietary control sequences used for this embosser
• # Warning -- page size maximum needs to be compiled into driver source code
• # Notice the use of Customize for small line spacing
• # Customize = 2 -- small spacing 235/900 inches/line
• # Customize = 3 -- middle spacing 274/900 inches/line
• # Customize = 4 -- large spacing 314/900 inches/line (command not needed. large is the default)
• # Customize = 5 -- unsure if this is a valid spacing
• # Customize = 6 -- ST spacing. exact spacing depends on page size
• Driver = "Emb_Gemini_EmbosserDriver"
• SubModel = 1
• StartLeftMargin = 0
• Interline
• Customize = 2
• MaximumCells = 32
• MaximumLines = 24
• NarrowWarning
• NoLeftMargin
• NoRightMargin
• NoTopMargin
• YesUSB
• HelpPage = "Nippon_Super_Gemini_(small_spacing).htm"
• Form "10_n" = 85 x 100 ; SinglePage;
• BrailleOnly = 32 x 22 ; 32 x 22 ;
• Interline = 32 x 22 ; 32 x 22
• Form "11_n" = 85 x 110 ; SinglePage;
• BrailleOnly = 32 x 24 ; 32 x 24 ;
• Interline = 32 x 24 ; 32 x 24
• Form "11_gem" = 100 x 110 ; SinglePage;
• BrailleOnly = 32 x 24 ; 32 x 24 ;
• Interline = 32 x 24 ; 32 x 24
• Form "12_n" = 85 x 120 ; SinglePage;
• BrailleOnly = 32 x 26 ; 32 x 26 ;
• Interline = 32 x 26 ; 32 x 26